|
|||||||
|
PRODUCTS IP TELEPHONY LEGACY TDM R1 Signaling HOW TO BUY BECOME OUR RESELLER / DEALER SUPPORT ABOUT |
R1 Signaling
Telesis Systems Offering R1 Signaling
Standards and interfacesTelesis PX24X , X1 and Stillink support signaling for two-bit R1 line / MFR1 interregister according to ITU-T recommendations. Telesis PX24M, PX24X, and X1 support signaling for MFR1 interregister on analog Type-V E&M interfaces.
Telesis systems have R1 signaling E1 and E&M interfaces to connect to PSTN and private network OptionsThe physical interface for single-bit and two-bit signaling is E1 (ITU-T G.703). 120 ohm balanced terminations are supported on any E1. The line code is HDB3 or AMI programmable. CRC4 may be enabled or disabled. Each E1 channel can be programmed as incoming, outgoing, bothway trunk, or unavailable. Route, Routeset Configuration, RoutingIn a Telesis system, each E&M interface and E1 channel may have its own route number. It is possible to define numerous distinct routes. A given route to a particular destination and its accompanying routes are grouped in a routeset. Each route in a routeset has a priority order. Routing to the next priority alternate route is possible in the event that a route becomes unavailable. The Telesis system realizes routing according to the dialed digits or calling party number. Related ReadingsWe recommend you to visit Telesis WiKi Pages for technical readings.
|
||||||
|
© Telesis A.S. 2006-2010 |
|||||||